1, Photocoupler isolation between input control signal and controlled power, isolation surge voltage up to 7500V.
2, Input signal turn-on voltage DC 3 to 32V, turn-off voltage DC 0 to 0.8V. LED indication for relay turn-on.
3, Output voltage range: AC 90 to 250V(50/60Hz). Maximum on-state average current 3 Amp. Maximum on-state current 10 Amp (< 10 seconds). Non repetitive surge peak on-state current: 120 Amp (<20mS). Load type: General purpose.
4, This is a simple and practical solid state relay module, which is very convenient to use, for Arduino, Raspberry Pi, ESP32, PLC or other projects. The GPIO of these controllers are directly connected to this relay input to control the mains power, and it is suitable for most loads less than 350 Watts (for 115VAC)/700 Watts (for 230VAC).
5, Compact ABS plastic case and wires connect for easy mount. Two screw mounting holes are convenient for you to fix it on the wall or wooden board. Of course, you can also choose not to lock the screw.
6, Compared with traditional electromagnetic relays, it has the advantages of long operating life, rapid on-off, no ignition arc and bounce, thus reducing electromagnetic interference. In addition, its action is quiet and does not produce annoying "ka-da" sounds.
Characteristic Parameters:
Input Signal Control Terminal:
Action Voltage: 3 ~ 32 VDC.
Current: 5mA at 3VDC, 6mA at 5VDC, 8mA at 12VDC, 11mA at
24VDC, 13mA at 32VDC.
Turn off voltage: 0 ~ 0.8 VDC.
In-Out isolation surge voltage: 7500V.
Output Terminal:
Load voltage range: 90 to 250 VAC (50/60Hz).
Max. on-state average current: 3 Amp.
Max. on-state current: 10 Amp (< 10 seconds).
Non repetitive surge peak on-state current: 120 Amp (<20mS).
Max. on-state voltage drop: 1.5V.
Max. off-state current: < 2mA / at 220VAC.
Off-state max. allow voltage: 400V.
Isolation: Phototriac.
Zero cross: Yes.
Load type: General purpose.
USD
EUR
GBP
CAD
AUD